Preparation For Storage - Arctic Cat 400 3in1 Owner's Manual

!! CAUTION !!
Prior to storing the ATV, it must be
properly serviced to prevent rusting
and component deterioration.
ARCTIC CAT recommends the
following procedure to prepare
the ATV for storage. A specialized
workshop should perform this serv-
ice; however the owner/operator
may perform this service if desired:
1. Clean the seat cushion with a
damp cloth.
2. Clean the ATV thoroughly by
washing dirt, oil, grass and other
foreign matter from the entire ATV.
DO NOT get water into any part of
the engine or air intake. Allow the
ATV to dry thoroughly.
3. Either drain the gas tank or add a
fuel stabilizer to the gas in the gas
tank. Remove the air filter. Start
the engine and allow it to idle. Then
using Arctic Cat Engine Preserver,
������ �� � ��
��������������� ��
������� ��� � ��� ����������
���������� ������������
ENGLISCH
rapidly inject the preserver into the
air filter opening for a period of 10
to 20 seconds. Install the air filter.
!! CAUTION !!
If the interior of the air filter housing
is dirty, clean the area before start-
ing the engine.
4. Drain the carburetor float bowl.
5. Plug the hole in the exhaust sys-
tem with a clean cloth.
6. Apply light oil to the upper steer-
ing post bushing and plungers of
the shock absorbers.
7. Take care that all screws, nuts
and holding components are tight-
ened properly.
8. Clean the ATV thoroughly.
9. Disconnect the battery cables
(negative cable first); then remove
the battery, clean the battery posts
and cables and store in a clean, dry
area.
10. If possible, store the ATV in-
49

Preparation for storage

doors.
!! CAUTION !!
Avoid storing outside in direct sun-
light and avoid using a plastic cover
as moisture will collect on the ATV
causing rusting.
���������� ����������� ��������
21.05.2006, 14:49 Uhr
Page 47
�����������������