Set Parameter In The Action Mode; Set Parameter In The System Setup Mode - Beamz LCB-384 User Manual

POWER OUT
POWER IN

Set parameter in the Action Mode

1. Power on until it resets ok and press Up or Down to display Act.
2. Press Enter and then press UP or Down to choose which kind of action mode you need.
3. Press Enter and then press UP or Down for adjustment , press Enter to the next parameter
when there are many parameters .
4. Press Mode to exit .
Note: Digital means the parameters.
Axxx action mode.
Fxxx Flash Speed, F=000 no flash, F=100 Flash
by sound.
Pxxx Run Speed, P=000 Stop running P=50
Fastest speed P=051-100 Sound Active.
A021 Digital means functions：
P000-P100, Red
F000-F100, Green
C000-C100, Blue

Set parameter in the System Setup mode:

1. Power on until it resets ok and press Up or Down to display SYS .
2. Press Enter and then press UP or Down to choose which kind of parameter you need.
3. Press Enter and then press UP or Down to adjust .
4. Press Mode to exit .
Note：
When display S DAD and press Enter to set up DMX value .
When display S AAD and press Enter to display 8888, it resets ok with all light on.
5. Factory parameter Settings
With the factory parameter setting function, users can go back the factory parameter setting
after adjusting by pressing the button of Mode for five seconds or so.
Maximum connecting machines are
15 units with the same model
‐ 5 ‐