Local Operations; Using The Wizard; Login - Grandstream Networks GVR3550 User Manual

LOCAL OPERATIONS

In this chapter, we take using the mouse as an example.

USING THE WIZARD

Users could start the GVR via the wizard for basic configuration to make it work properly.
1. Enter administrator password (the default is "Admin") to log in the GVR. Check to confirm whether to
enable the wizard next time when boot up the device;
2. Click on "Next" to access Basic Settings page to configure language and time. Set time zone and system
time;
3. Click on "Next" to access Network Settings page to set IP address, subnet mask and gateway
parameters;
4. Click on "Next" to access HDD Management page to set HDD array and HDD full strategy;
5. Click on "Next" to access Camera Management page to add camera;
6. Click on "OK" to finish setup.

LOGIN

The factory default username is "admin", the password is "admin". Users have to login again if timeout
without operations. Password change is recommended after the initial login.
After logging in the GVR local page, users could click on the menu button
the page to login, or click right mouse and then select any item in a pop-up menu to bring up the GVR login
page.
GVR3550/GVR3552 User Manual
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
in the lower left corner of
Page 34 of 121