CallNg StatOn Id NdCatOn For Group Call - Icom IC-F43GT Instruction Manaul

• Erasing the call back memory
q Push [Call Back] then select the desred call back memory
to be erased wth [Up]/[Down].
w Push and hold [Call Back] for 2.5 sec. to erase the se-
lected call back memory.
• All the stored call back memory can be erased wth the
same operaton as above dependng on the settng.
• When all of the 15 call back memores are stored and
16th call s receved, the called staton sent the message,
"Don't Dsturb" to the system repeater. In ths case, the
message that the call has faled s dsplayed on the call-
ng staton dsplay.
■ Calling station ID indication
for group call
The communcatng staton code can be dsplayed at any
tme.
Ths functon can be turned ON or OFF n advance.
The "Pressel sgnal" from the callng transcever s used for
the ndcaton, however, the "Pressel sgnal" s not through out
wth some trunkng system repeater. No staton code ndca-
ton s provded n ths case.
NOTE: Ths functon may functon dfferently or not func-
ton dependng on the trunkng system controller n place.
OTHER FUNCTIONS
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
23