Attaching The Needle Bar Cover; Attaching The Button Tray Assembly; Threading The Machine - JUKI MB1373 Instruction Manual

2-4. attaching the needle bar cover

WarnInG :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
4

2-5. attaching the button tray assembly

3

2-6. threading the machine

WarnInG :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
A
!6
!7
!8
@0
@1
Thread the machne head n the order of 1 to @1 as shown n the llustraton gven above. Then, pass the
thread through the needle eye from the front for approxmately 60 to 70 mm as you depress npper releasng
knurled thumb nut A .
* Standard needle s TQ X 1 #16.
1
3
2
1
2
!4
!0
!1
!5
!3
!2
!9
1) Loosen screw 2 and remove thread gude 3 .
2) Place needle bar guard 1 under thread gude
3 and attach thread gude 3 so that lever 4
comes to the center of t at the start of the ma-
chne.
3) Fx the cover wth screw 2 .
Insert the posts of button tray 1 n hole on the rght
of the machne sub-base and tghten each setscrew
2 . If it is difficult for the operator to pick up the but-
tons on the rght sde, change t to hole 3 on the left
sde.
5
7
9
8 6 4
– 3 –
2
1
3