Adjusting How The Sound Will Respond To; Strike Position; D-Beam Settings; Calibrating The D-Beam - Roland HandSonic HPD-20 Owner's Manual

SYS
PAD SETTINGS–POSI
MENU g SYS g Pad Settings g POSI
Parameter
Adjusting how the sound will respond to strike position
Position Area
D-BEAM Settings
D-BEAM SETTINGS
MENU g SYS g D-BEAM Settings
In the kit screen, [SHIFT] + [D-BEAM]
Button
Calibrating the D-BEAM
The D-BEAM's sensitivity and response curve will be affected by the brightness of the location.
You can adjust these to obtain the desired performance.
[F1] (DEFAULT)
[F2] (SET-MIN)
[F3] (SET-MAX)
ExtTrig Settings
EXT-TRIGGER SETTINGS–TYPE
MENU g SYS g ExtTrig Settings g TYPE
Parameter
Specifying the type of external expansion pad
By specifying the type of external expansion pad that's connected, the optimal settings for sensitivity and other parameters for that pad
can be set in a single step.
Type
62
Explanation
Adjusts how the tonal character (p. 14) will be affected by the position at which you
strike the M1 or M2 pads.
As you increase this value, it will become easier to produce tonal change by striking
the edge.
If this is "OFF, " striking the edge will not produce tonal change.
The default value is "2. "
* This setting is common to M1 and M2.
Explanation
Sets the calibration parameters to the default values.
Position the palm of your hand above the D-BEAM at the highest position that you want to use, and press the
[F2] (SET-MIN) button. The high position will be set.
Position the palm of your hand above the D-BEAM at the lowest position that you want to use, and press the
[F3] (SET-MAX) button. The low position will be set.
Explanation
Specifies the type of external expansion pad that's connected.
* If "Type" is "FOOT SW, " the parameters in [F2] (SENS) and [F3] (ADVNCD) will have no effect.
Center
Edge