Installation; B-520-Rx-230-Ir Receiver Installation; Applications - Binary B-520-RX-230-IR Installation Manual

5. INSTALLATION

CAUTION: Do not connect power to the device until all other connections are
made and the unit is installed.

5.1. B-520-RX-230-IR Receiver Installation

1. Run Category cable from the location of the Matrix switcher or transmitter to
the remote location of the receiver.
2. Mount the receiver in the desired location.
3. Connect the Category cable to the receiver HDBaseT RJ45.
4. Connect an IR flasher and/or IR receiver if being used. Refer to Section 6.2.
5. Connect an HDMI cable from the HDMI Out of receiver to the display.
6. If the receiver is paired with a non-PoC transmitter, connect an optional
power supply (B-PS-12VDC-2A). When the receiver is connected to a Matrix
switcher, no power supply is required.
7. Connect the power supply to the AC outlet.

6. APPLICATIONS

IR IR
Flasher Receiver
Note: When a receiver is paired with a Matrix switcher, the HDBaseT link sends
power to the other unit.
HDMI Source
B-520-MTRX-230-8x8 Switcher
B-520-RX-230-IR Receiver
HDMI OUT
Back
HDTV
FIGURE 2 : Application Diagram –Matrix
PLAY
OFF
IR FLASHER
LEVEL
12V DC
Front
6
12V DC
INPUT