Ir Control Connections - Binary B-520-RX-230-IR Installation Manual

6.2. IR Control Connections

Bidirectional IR signals can be transmitted between a Matrix switcher or transmitter
and the receiver through Category cable. The IR signal can be generated either from
the powered receiver or from a control system. The following section describes
these two use cases.
CAUTION: Pinout configurations for IR receivers and control systems vary.
Before connecting to this input, review this section carefully in order to match
the pinouts for the device.
IR Processor/ Controller
IR Outputs
Note: Arrow direction indicates signal flow.
 IR Receiver In-3.5 mm Mono—See Section 6.2.2
 IR Receiver In-3.5 mm Stereo—See Section 6.2.1
 IR Flasher Out-3.5 mm Mono—See Section 6.2.3
D HDBaseT Link Category cable (RJ45)—See Section 6.1
IR Inputs
B-520-MTRX-230-8x8 Switcher
A
B-520-RX-230-IR Receiver
C B
IR IR
Flasher Receiver
HDMI OUT
Back
FIGURE 4 IR Connections – Matrix Switcher
HDMI Source
C
OFF
IR FLASHER
LEVEL
12V DC
HDTV
8
PLAY
HDBaseT
12V DC
INPUT
D
Front