6.2.1. Point-to-Point IR Control - Stereo (3.5mm) IR Receiver
When using a powered IR receiver, the DIP switch for IR RCVR PWR should be set
to ON. In this case a 3.5mm (1/8") stereo jack has to be used to send 9V DC power
to the receiver.
CAUTION: Do not connect a mono cable to this connection as damage may
occur.
DIP Switches
6.2.2. Control System - Mono (3.5mm) IR Receiver
When using a control system which generates the signal through a mono jack, the IR
RCVR PWR switch should be in the OFF position.
DIP Switches
6.2.3. IR Flasher Out-3.5mm Mono
The IR Flasher level adjusts the intensity of the IR Flasher output
GND (Sleeve)
IR Signal (Tip)
6.4. HDMI Out
We recommend using an HDMI cable that is one meter or less to ensure the highest
signal quality.
9V DC(Sleeve)
GND (Ring)
IR Signal (Tip)
1
FIGURE 6: Point-to-Point IR settings
GND (Sleeve)
1
IR Signal (Tip)
FIGURE 7: Control System IR settings
Pinout Configuration
FIGURE 8: IR Flasher Out
Pinout Configuration
Pinout Configuration
10