Installation; B-540-Ext-330-Rs-Ipw Transmitter Installation; B-540-Ext-330-Rs-Ipw Receiver Installation - Binary B-540-EXT-330-RS-IPW Installation Manual

M. Optional Remote Power (2 Conductor Removable)
Optional connection for power from a remote power source; 2/18 wire required
Note: Use only when the Latch-Locking Power Jack is not being used. Do not connect both
power sources.
N. HDBaseT (RJ45 )
To connect to the HDBaseT RJ45 port on transmitter

5. INSTALLATION

5.1. B-540-EXT-330-RS-IPW Transmitter Installation

CAUTION: Do not connect power to the device until all other connections are made and the unit
is installed.
1. Run category cable from the location of the transmitter to the remote location of the receiver.
2. Mount the device transmitter in the desired location.
3. Connect the category cable to the device transmitter.
4. Connect the HDMI Out of a source component to the HDMI In of the transmitter using an
HDMI cable.
5. Connect the RS-232 DB-9 from a control system if being used.
6. Connect an IR control system to the IR receiver and/or IR flasher if being used. Refer to
Section 6.2.
7. Connect an ethernet RJ45 cable to an ethernet enabled device if being used.
8. Connect the 12V DC, 2A power supply to the thread-locking power connector unless PoC
is being used to send power from the receiver. DO NOT plug the power supply into an AC
outlet until Receiver Installation is completed.

5.2. B-540-EXT-330-RS-IPW Receiver Installation

1. Run category cable from the location of the transmitter to the remote location of the receiver.
2. Mount the device receiver in the desired location.
3. Connect the category cable to the device receiver.
4. Connect an IR flasher and/or IR receiver if being used. Refer to Section 6.2.
5. Connect an HDMI cable from the HDMI Out of device receiver to the display.
6. Connect the RS-232 DB9 to an RS-232 controllable source if being used.
7. Connect an ethernet RJ45 cable to an ethernet enabled device if being used.
8. Connect the 12V DC, 2A power supply to either the thread-locking power connector, or
the optional remote power connector, unless PoC is being used to send power from the
transmitter.
9. Connect the power supply to the AC outlet.
7