Heat & Glo 6000C-IPI Owner's Manual page 61

2 2
Figure 7
Log #3 (SRV2164-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been fi tted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and slide Log # 3 toward the right until it rests against the far right grate tine (see Figure 7).
Log #4 (SRV2164-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right
to left under Log #2 to fi t completely and securely into the indentation (see Figure 8). Nose of log #4 should be pulled to fi t
securely against right hand side of log indentation.
FLAT AREA FLAT AREA
2 2
4 4
Figure 9
Log #5 (SRV2164-705): Place Log #5 in the right log
indentation on the burner top (see Figure 2). Ensure the
log fi ts completely and securely in the recessed indentation
(see Figure 9). Log #5 should be pulled to the left hand side
of log indentation.
Log #6 (SRV2164-706): Mate the groove located on the
lower end of Log #6 with the fourth grate tine (from left to
right) as shown in Figure 10. Set the other end of Log #6
on the fl at area located on top of Log #4 (see Figure 9). Log
#6 will also rest against center grate tine. When properly
installed, Log #6 will rest securely on all 3 contact points,
not allowing movement or shifting.
Ensure the log set is in proper position by measuring from
the front of Log #1 to the refractory as shown in Figure
11. The measurement will be 6 inches if logs are placed
properly.
RIGHT GRATE TINE RIGHT GRATE TINE
1 1
3 3
1 1
3 3
5 5
2164-935D
Heat & Glo • 6000C-IPI, 8000C-IPI • 2164-900 Rev. AB • 10/15
2 2
4 4
Figure 8
LOG #6 CONTACTS TOP OF LOG #4 LOG #6 CONTACTS TOP OF LOG #4
2 2
4 4
LOG CONTACTS GRATE TINES LOG CONTACTS GRATE TINES
Figure 10
Figure 11
NOSE NOSE
1 1
3 3
1 1
3 3
5 5
6 6
61