Sub-Zero 601R Installation Manual page 9

C O M P L E T I N G T H E I N S T A L L A T I O N
CAUTION
Protect any finished flooring before moving the unit in
place. All full-size Sub-Zero models are equipped with
rollers, so you can easily move the unit into place. If for
any reason the unit has been laid on its back or side,
you must allow the unit to stand upright for a minimum
of 24 hours before connecting power.
Step 8: To complete the installation, first shut off power
to the wall outlet. Plug into a 15 amp grounded outlet
and roll the unit into position under the wood block or sof-
fit. Now you have to connect the ice maker water line.
Remove the 1/4" compression fitting from its plastic bag
and join the water supply line to the solenoid valve.
If desired, the water valve can be removed from mounting
bracket to gain easier access to water connection, as shown
in illustration 8. Purge the line before making the final con-
nection. Illustration 9 applies only to Model 680 and 690.
IMPORTANT NOTE: Turn on the water supply and
check all fittings for leaks. Make certain the electrical
harness is attached to the solenoid.
In areas with water of high mineral content, the use of an
in-line water filter is recommended. Make sure the filter is
positioned and accessible for replacement when necessary.
IMPORTANT NOTE: Let your customer know that the
ice maker will not fill with water immediately, and
that the first three batches of ice produced should be
discarded. Allow 24 hours for proper ice production.
ELECTRICAL
CONNECTION
SOLENOID
VALVE
Illus. 8
6 0 0
S E R I E S
1
/ "
4 COMPRESSION NUT
SLEEVE
1
/ "
4 COPPER
Illus. 9
Step 9: Now, level the unit. To adjust the height, turn the
front leveling legs counterclockwise to lower it. Adjust the
rear levelers from the front of the base. Turn the 5/16" hex
bolt clockwise to raise the cabinet, counterclockwise to
lower the cabinet. Refer to illustration 10. When the unit is
leveled properly, or squared off, door adjustments are less
likely to be necessary.
IMPORTANT NOTE: Be sure to reference leveling of the
unit to the floor and not to surrounding cabinetry, by using
the unit main frame and door trim as leveling reference
points. This could effect the operation of the unit, such as
door(s) not closing properly.
WARNING
To reduce the possibility of the cabinet tipping forward,
the front levelers must be in contact with the floor.
Step 10: After the unit has been leveled, install the kick-
plate as shown in illustration 11. Be sure the drain pan is
installed properly.
CAUTION
The kickplate must be removed for servicing. The floor
cannot interfere with removal. Refer to label mounted
on kickplate support for height clearance.
REAR
ADJUSTMENT
FRONT
LEVELERS
Illus. 10
Step 11: Replace the grille by reversing the procedure in
Step 6 and turn the power back on. If you're using a panel
grille, refer to Installing Overlay Grille Panels, page 13.
9
Illus. 11