Sub-Zero 601R Installation Manual page 11

I N S T A L L I N G F R A M E D P A N E L S
M O D E L 6 8 0 A N D 6 9 0
If you're installing a Model 680 or 690 refrigerator / freezer,
first remove the door handle and trim. The screws are hid-
den by a magnet-backed trim molding. Remove the molding
using a piece of tape to pull it away from the handle and
expose the handle screws. The trim molding will bend out at
the center to allow you to remove it.
With a Phillips screwdriver, remove the door handles on
freezer and refrigerator doors. The door handles also act as
a door trim.
Remove the handle trim panels by sliding them out of the
doors. Different colored handle trim panels and glasswells
are available through your Sub-Zero dealer.
Next, remove the water and ice glasswell by removing the
mounting screw. Then slide the glasswell up and pull it out.
Remove the top and bottom trim fillers held on by the
mounting screws, and the screws holding the vertical trim
strip. Install the door panels by sliding them into the frame
on the door. Refer to illustrations 14 and 15. With the door
panels in place, reverse the steps to reassemble.
Illus. 14
6 0 0
S E R I E S
Illus. 15
P A R T I A L F R A M E D A C C E S S O R Y K I T
M O D E L 6 8 5 A N D 6 9 5
If you choose not to use custom wood panels above or
below the glasswell for Model 685 or 695 framed applica-
tion, a stainless steel insert panel will be provided with the
partial framed accessory kit. This accessory kit (part
# FRAMPAR / #0000034), available through your Sub-Zero
dealer, includes molding and a stainless steel insert panel
for above and below the glasswell on a framed unit.
Detailed installation instructions are included with the par-
tial framed accessory kit.
F R A M E D R E T R O F I T A C C E S S O R Y K I T
M O D E L 6 8 5 A N D 6 9 5
With the framed retrofit accessory kit, existing Model 680
or 690 door panels can be used on a new Model 685 or
695 framed unit. This accessory kit (part # FRAMRET /
#0000035), available through your Sub-Zero dealer,
includes moldings and stainless steel insert panels to
accommodate existing Model 680 or 690 framed door
panels.
Detailed installation instructions are included with the
framed retrofit accessory kit.
A C C O M M O D A T I O N S F O R R A I S E D
P A N E L S
You may have to rout, recess or use optional extended han-
dles with some door panel designs to allow for finger clear-
ance. This is particularly true if your unit has raised panels
greater than 1/4" (6) total thickness. Remember, there is a
maximum weight limit of 50 lbs (23 kg) per door panel as
well.
Check the location of offset when you're using specific rout-
ing for the grip area only. Refer to the 600 Series section of
the Sub-Zero Design Guide for a full-scale template of the
standard full length handle and panel. Use this grid tem-
plate to lay out your panel design for finger clearance when
standard full length handles are used.
11