Mounting The Push Brace; Adjustment Of The Push Brace - R82 Cougar User Manual

A
A
G
B
A
B
A
14
MOUNTING THE
GB
PUSH BRACE
Follow the instructions below to mount the push
brace.
1) Remove the ferrules (A) at the top of the
frame.
2) Push the push brace into the slides, and
tighten the 2 screws (B) in each side.
The top screw is fitted to the mark in the
slide to secure that the push brace can not
be pulled up when in use.
3) Mount the ferrules (A) again.
ADJUSTMENT OF
GB
THE PUSH BRACE
The angle of the push handle is easy to adjust
so that it can be used by carers of different
heights.
1) Press down the locking pin (A) and pull the
handle to release the push handle.
2) Adjust the angle.
3) Push in the handle and make sure the locking
pin "clicks" into place.
Do not pull/lift the chair with the push
handle, especially on stairs.