Appendix C
RAID Controller Considerations
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
How To Enable the ICH10R Onboard Controller
To enable the ICH10R onboard controller, follow these steps:
Boot the server and watch for the F2 prompt during bootup.
Step 1
Press F2 when prompted to enter the BIOS Setup utility.
Step 2
Select the Advanced tab of the BIOS Setup utility.
Step 3
Select Mass Storage Controllers Configuration.
Step 4
Step 5
Set Onboard SATA Controller to Enabled.
Step 6
Set SATA Mode to SW RAID.
Press F10 to save your changes and exit the utility.
Step 7
OL-20887-02
Cisco UCS C210 Server Installation and Service Guide
C-3