Cisco UCS C210 Installation And Service Manual page 74

Installing or Replacing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Align the PCIe card connector with the riser card socket and push on both ends of the card evenly
b.
to fully engage the card connector with the riser card socket (see
Install the screw that secures the rear plate of the card to the assembly rear opening.
c.
Replace any cables that were connected on the old card to connectors on the new card.
d.
Set the assembly in place, aligning the riser cards with the PCIe slots on the motherboard.
e.
Press down evenly on both ends of the assembly to fully engage the riser cards with the PCIe slots
f.
on the motherboard.
Replace the screw that secures the assembly to the chassis.
g.
Replace the top cover.
h.
Replace the server in the rack, replace power cords and any other cables, and then power on the
i.
server by pressing the Power button.
Figure 3-17
Figure 3-18
1 Riser card assembly removed from chassis
(top view)
3 PCIe card
5 PCIe card securing screw (attaches to assembly)
Cisco UCS C210 Server Installation and Service Guide
3-32
PCIe Slot Numbering and Physical Orientation, Facing Server Rear
PCIe Slot 4
PCIe Slot 5
Removing and Replacing a PCIe Card
1
2
3
PCIe Slot 1
PCIe Slot 2
PCIe Slot 3
4
5
2 Riser card
4 PCIe card rear plate
Chapter 3 Maintaining the Server
Figure 3-18).
OL-20887-02