Cisco UCS C210 Installation And Service Manual page 24

Installing the Server Into a Rack
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Push the mounting bracket toward the server rear until the locking clip clicks over the server peg.
b.
Attach the remaining mounting bracket to the opposite side of the server.
c.
You can optionally use the #1 Phillips screws that come with the slide rails to increase stability after
Tip
installation. You can install two of these screws on each side of the server to more permanently attach
the mounting brackets to each side of the server, but they are not required.
Figure 2-3
1 Rear of server
3 Mounting bracket
5
Installation release clip
Insert the server into the slide rails:
Step 3
This server weighs approximately 50 pounds (23 kilograms) when fully loaded with components. We
Caution
recommend that you use a minimum of two people when lifting the server. Attempting this procedure
alone could result in personal injury or equipment damage.
Align the mounting brackets that are attached to the server sides with the front of the empty slide
a.
rails.
Push the server into the slide rails until it stops at the internal stops.
b.
Push the plastic installation release clip on each mounting bracket toward the server rear (see item
c.
4 in
rack posts.
Close the front-flange latches to secure the server to the front rack posts.
d.
Attach the (optional) cable management arm (CMA) to the rear of the slide rails:
Step 4
The orientation in these instructions refers to a view from the front of the server.
Note
Slide the plastic clip on the right end of the CMA length-adjustment slider (item 2) into the rear of
a.
the right slide rail (item 1) until it clips onto the plastic retaining flange inside the slide rail. See
Figure
Expand the CMA length-adjustment slider (item 2) until its left end aligns with the rear of the left
b.
slide-rail assembly (item 3).
Cisco UCS C210 Server Installation and Service Guide
2-6
Attaching Mounting Brackets to the Server
1 2
3
Figure 2-3), and then continue pushing the server into the rack until its front flanges touch the
2-4.
4 5
2 Mounting peg (four)
4 Removal release clip
Chapter 2 Installing the Server
OL-20887-02