Cisco UCS C210 Installation And Service Manual page 103

Appendix D Installation for Cisco UCS Integration
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Attach a power cord to each power supply in your server, and then attach the power cord to a grounded
Step 4
AC power outlet. See the
Wait for approximately two minutes to let the server boot in standby power during the first bootup.
You can verify power status by looking at the Power Status LED on the front panel (see
page 1-1):
• Off—The server is not receiving power. Check the power cord connections and the power source of
the facility.
Blinking green—The server is in standby power mode. Power is supplied only to the service
•
processor and some motherboard functions.
Solid green—The server is in main power mode. Power is supplied to all server components.
•
Note During bootup, the server beeps once for each USB device that is attached to the server. Even if there
are no external USB devices attached, there is a short beep for each virtual USB device such as a virtual
floppy drive, CD/DVD drive, keyboard, or mouse. A beep is also emitted if a USB device is hot-plugged
or hot-unplugged during BIOS power-on self test (POST), or while you are accessing the BIOS Setup
utility or the EFI shell.
Use the supplied KVM cable to connect a keyboard and VGA monitor to the console connector on the
Step 5
front panel (see
Alternatively, you can use the VGA and USB ports on the rear panel. However, you cannot use the front
Note
panel console connector VGA and the rear panel VGA at the same time. If you are connected to one VGA
connector and you then connect a video device to the other connector, the first VGA connector is
disabled. You can then reactivate the first VGA connector only by rebooting the server.
Reboot the server so that it is discovered by the Cisco UCS Manager software.
Step 6
To view and configure settings for the server from within the Cisco UCS Manager software, see the
Step 7
information instructions in the
OL-20887-02
"Power Specifications" section on page A-2
Figure 1-1 on page 1-1).
Cisco UCS Manager Configuration Guide for Release 1.4(1)
Installing a Release 1.2(2) or Later Server for Cisco UCS Integration
for power specifications.
Cisco UCS C210 Server Installation and Service Guide
Figure 1-1 on
or later.
D-3