Connect Using Wcn 2.0 - D-Link DIR-412 User Manual

Mobile wireless router

Hide thumbs Also See for DIR-412:

Table of Contents

Section 5 - Connecting to a Wireless Network

Connect Using WCN 2.0

The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista

. The following instructions for setting

this up depends on whether you are using Windows Vista

to configure the router or third party software.

When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection,

the router must be both enabled and configured. There are three basic methods to accomplish this: use Windows

Vista's built-in support for WCN 2.0, use software provided by a third party, or manually configure.

If you are running Windows Vista

, log into the router and click the Enable checkbox in the Advanced > Wi-Fi Protected

Setup window. Use the Current PIN that is displayed in the PIN Settings section of Advanced > Wi-Fi Protected

Setup window or choose to click the Generate New PIN button or Reset PIN to Default button.

If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished,

proceed to the next section to set up the newly-configured router.

D-Link DIR-412 User Manual

Table of Contents