Connect To Cable/Dsl - D-Link DIR-412 User Manual

Section 2 - Installation
If your Internet connection is provided using a cable/DSL/satellite modem, carry out the following procedure before
connecting the router to a cable/DSL/satellite modem:
• If using the DIR-412 for the first time, please select the default mode as 3G Router to adjust your
configuration. Move the toggle switch on the back of the router to the 3G Router mode position.
• Configure the wireless settings on the DIR-412 in 3G Router mode (see the Wireless Settings page
more information).
• After configuring the wireless settings, move the switch to the WAN Mode position and wait for the device
to reboot.
To connect to a cable/DSL/Satellite modem, please follow the steps below:
1. Unplug the Ethernet cable (that connects your computer to your modem) from your computer and place it into the
Ethernet port on the router.
2. Plug the power adapter into the router and connect it to an outlet or power strip. Wait about 50 seconds for the router
to boot.
3. Connect the DIR-412 to your computer wirelessly using the settings (SSID, encryption key) you configured
previously.
4. Verify the link lights on the router. The power light, Internet light, and the Wireless LAN light should be lit. If not,
make sure your computer, modem, and router are powered on and verify the cable connections are correct.
D-Link DIR-412 User Manual

Connect to Cable/DSL

for
11