Travis Industries 864 HO GS Installation Manual page 50

50
6 Install the new manifold cover included in the LP conversion kit (see illustration below).
7 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice
Lift the pilot hood
a
off the pilot
assembly.
8 Replace the burner. Push the burner to the right side to insure the manifold inserts over the
orifices.
9 Install the rivet included in the LP conversion kit into the hole shown below.
© Travis Industries
Installation
(for qualified installers only)
Use a hex wrench to
b
unscrew the orifice.
5/32" Hex
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
Remove the orifice and replace with the LP orifice. Screw the
c
orifice all the way in and replace the pilot hood.
4100728
Orifice Identification:
LP (Propane) Orifice
35
35
NG (Natural Gas) Orifice
62
100-01254_000