Range Hood Care; Cleaning - KitchenAid KVWB400DSS0 Installation Instructions And Use & Care Manual

30" (76.2 cm) and 36" (91.4cm) wall-mount canopy range hood
Table of Contents

Advertisement

Available languages

Available languages

RANGE HOOD CARE
Cleaning
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning
Method:
Liquid detergent soap and water, or all-purpose
cleanser
Non-Vented (Recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit Number
W10272068.
To Replace Charcoal
Filter:
1. Cover the grille that covers the blower motor with the
charcoal filter so that the slots on the filter correspond to the
pins on the sides of the motor grille.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filter:
1=
Open the stainless steel panel. Grasp panel at the front
corners and pull down to disengage the 2 catch pins from the
spring catches. The panel is attached at the rear and will
rotate down.
A
2.
C
A. Metal filters
B. Stainless steel panel
C. Catch pins (2)
D. Spring catches (2)
Remove each filter by pulling the spring release handle and
then pulling down the filter.
A. Spring release handle
3. Wash metal filters as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
5. Push in spring release handle.
6. Push up on metal filter and release handle to latch into place.
7. Repeat steps 1-5 for the other filter.
8. Close the stainless steel panel. Engage the (2) pins in the
spring catches to secure.
J
A
B
C
A. Charcoal filter
B. Pins
C. Blower motor
2. Turn the charcoal filter clockwise to lock it.
3. Repeat steps 1-2 on the other filter.
Replacing
a Led Lamp
The LED lights are replaceable by a service technician only. See
"Assistance
and Service" section for service contact information.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kvwb406dss0

Table of Contents