Kenmore 58714403400 Installation Instructions Manual page 6

Installation Instructions
[ STEP 21 ADJUST LEVELING LEGS
• Move the dishwasherclose to the installation location and lay
it on its back.
/
Adjust to
Installation
Height
Figure H
I
_ o
• Measureinstallation heightand dishwasherheight.Extend
levelinglegs out from the dishwasherbase, 1/4" less than
installation height.
[STEP31
REMOVE TOEKICK
• Removethe 4 toekick screws. Lift off the 2 piecetoekick.
Figure J
lSTEP 4] INSTALL 90 ° ELBOW
• Wrap90 ° elbow with thread seal tape.
• Install a 90° elbowonto the water valve.
Fill
Hose
90°
Elbow
Thread
Figure L
Seal Tape
Water
Valve
Bracket
• Do not overtighten 90 ° elbow, water valve bracketcould
bendor water valve fitting could break.
• Positionthe end of the elbow to face the rear of the
dishwasher.
6