Kenmore 58714403400 Installation Instructions Manual page 11

Installation Instructions
[STEP 13 ICONNECT POWER
SUPPLY
Skip this step if equipped with power cord,
Verify that power is turned off at the source,
• Removejunction box cover "A".
• Locatethe three dishwasherwires, (white, black and green)
with stripped ends.Insert dishwasherwires through the
small hole in the junction box"B'.
• Securehousewiring to the bottom of the junction boxwith a
strain relief "C'.
• User wire nuts to connectincominggroundto green,white to
white and black to black "O".
• Replace junction box cover "E". Checkto be surethat wires
are not pinchedunderthe cover.
E. ReplaceJunction Box Cover
WARNING
If housewiring is not 2-wire with ground,
a groundmust be providedby the installer.
Whenhousewiring is aluminum,be sure to
useUL Listed anti-oxidantcompoundand
aluminum-to-copper connectors.
ISTEP 14 IPRE-TEST CHECKLIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your warranty.
[] Checkto be sure power is OFF.
[] Opendoor and removeall foam and paperpackaging.
[] Locatethe Owner'sManualin the literature package.
[] Readthe Owner's Manualfor operatinginstructions.
[] Checkdoor openingandclosing.If door doesnot openand
close freely or tends to fall, checkspring adjustments.See
Step 1.
[] Checkto be sure that wiring is secureunder the dishwasher,
not pinchedor in contact with door springsor other
components.SeeStep 9.
[] Checkdoor alignmentwith tub. If door hits tub, level
dishwasher.See Step 10.
[] Pull lower rack out, abouthalf way. Checkto be sureit does
not roll back or forward on the door.If the rack moves,adjust
levelinglegs. See Step 10.
[] Checkdoor alignmentwith cabinet.If door hitscabinet,
reposition or releveldishwasher.See Step 10.
[] Verify water supply and drain lines are not kinked or in
contact with other components.Contact with motor or
dishwasherframe could causenoise. SeeStep 8.
[] Turn on the sink hot water faucet and verify water
temperature.Incomingwater temperaturemust be between
120°F and 150°F. A minimumof 120°F temperature is
requiredfor best wash performance.See"PrepareHot Water
Line",page5.
[] Add 2 quarts of water to the bottom of the dishwasherto
lubricate the pumpseal.
[] Turn on water supply. Checkfor leaks.Tighten connections
if needed.
[] Removeprotective film if presentfrom the control paneland
door.
11