MTU MW15406/17E Operating Instructions Manual page 106

Item
9
10
11
12
13
14
15
16
17
18
19
20
106 | Operation | MW15406/17E 2014-05
Color Inscription
White LAMP TEST
Red TEST OVERSPEED
Green (depending on type of
gearbox and propul-
sion)
Green
Green
White ENGINE SPEED IN-
CREASE
White ENGINE SPEED DE-
CREASE
Green READY FOR OPERA-
TION
Green LOCAL OPERATION
White START
White STOP
Red EMERGENCY STOP
Meaning / Function
Pressing the button initiates lamp test.
Pressing the button initiates overspeed test.
LED (spot) lights up as long as the overspeed test is run-
ning.
FPP: Pressing the button engages gear ahead.
CPP, WJ, VS: Pressing the button engages clutch.
LED (spot) lights up when GCU feedback is active.
FPP, CPP, WJ, VS: Pressing the button disengages clutch.
LED (spot) lights up when GCU feedback is active.
FPP: Pressing the button engages gear astern.
CPP, VS: No function assigned.
WJ: Holding down the button provides flushing of water jet
intake channel (water-jet reverse) .
LED (spot) lights up when GCU feedback is active.
Engine speed is increased as long as the button is held
down.
Engine speed is decreased as long as the button is held
down.
Pressing the button causes changeover between "Not
ready for operation" and "Ready for operation" status.
LED (spot) lights up at "Ready for operation" position.
Pressing the button activates changeover between local
and remote control mode.
LED (spot) lights up when local mode is active.
Pressing the button initiates the automatic engine start
sequence.
LED (spot) lights up as long as the starting procedure is
running.
Pressing the button initiates automatic engine stopping
procedure.
LED (spot) lights up as long as the STOP signal is available
(also if transmitted from RCS).
Pressing the button initiates an immediate emergency en-
gine stop.
LED (spot) flashes once the emergency stop has been
tripped and until the alarm has been acknowledged.