Kenmore 665.1272 Series Use & Care Manual page 16

Options
Can be selected
with
What it does
Added time to cycle
Typical Max
High Temp
Raises main wash temperature to
improve cleaning for loads containing
tough, baked-on food.
SmartWash ®HE
Pots & Pans
Normal Wash
Raises the main wash
temperature from 105°F
(41°C) to 130°F or 135°F
(54°C or 57°C).
35 45
Sani Rinse
This high temperature option sanitizes
your dishes and glassware in
accordance with NSF International
NSF/ANSI Standard 184 for Residential
Dishwashers. Certified residential
dishwashers are not intended for
licensed food establishments. The Sani
indicator indicates at the end of the
cycle whether the Sani Rinse option was
successfully completed. If the indicator
does not activate, it is probably due to
the cycle being interrupted.
SmartWash ®HE
Pots & Pans
Normal Wash
Increases the main wash
temperature from 105°F
(41°C) to 130°F (54°C) and
the final rinse from 140°F
(60°C) to 156°F (69°C).
6O 9O
Added
Water _
Gallons
(Liters)
0 - 2.6
(0- 10.0)
Heated Dry
Turns the heat element on after the wash
cycle is completed. Use rinse aid with or
without the Heated Dry option for best
drying results. Plastic items are less likely
to deform when loaded in the top dish
rack.
Available with
any cycle except
Quick Rinse
Turns the heat element on
at the end of the wash
cycle.
32
tThe maximum additional water used for any combination of options is 2.6 gal. (10.0 L).
32
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours
when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button.
3. Press START.
NOTE: Anytime the door is opened (such as, to add a dish), the START button must be pressed again to resume the delay
countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCI( ON is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold CONTROL LOCI( for 3 seconds. LOCI( ON will light up. If you press any pad while your dishwasher is locked, the
light flashes 3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold CONTROL LOCI( for 3 seconds. The light turns off.
16