Advertisement
ADDITIONAL SAFETY RULES
1. Handle the bits very carefully.
2. Check the bit carefully for cracks or damage before operation. Replace
3.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
4. Hold the tool firmly w i t h both hands.
5.
Keep hands away from rotating parts.
6.
Make sure the bit is not contacting the workpiece before the switch is turned
on.
7. Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate improperly installed bit.
8.
Be careful of the bit rotating direction and the feed direction. (cf. P .
7 )
9.
Do not leave the tool running. Operate the tool only when hand-held.
IO.
Always switch off and wait for the bit t o come t o a complete stop before
1 1. Do not touch the bit immediately after operation;
it
may be extremely hot
12.
Keep the bit retracted
so
as not t o protrude from the tool base except dur-
cracked or damaged bit immediately.
fore operation.
removing the tool from workpiece.
and could burn your skin.
ing actual operation.
SAVE THESE INSTRUCTIONS.
4
Advertisement
