ADDITIONAL SAFETY RULES
These bits come fully sharpened. Handle them carefully t o prevent injury.
Check the bit carefully for cracks or damage before operation. Replace
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
4. Make sure the shaft lock is released before the switch is turned on.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
Check the bit is not contacting the workpiece before the switch is turned on.
Before using the tool on an actual workpiece, let
simply run for several
minutes first. Watch for flutter that might
caused by poor installation or
a poorly balanced.
cracked or damaged bit immediately.
Be careful of the bit rotating direction and the feed direction.
not leave tool running. Operate the tool only when hand-held.
Always switch off and wait for the bit t o come t o a complete stop before
not touch the bit right after operation, it is extremely hot and could burn
Keep the bit retracted
as not t o protrude from the bottom except during
removing the router from workpiece.
SAVE THESE INSTRUCTIONS.