Install The Hood - Broan QP142BL Instructions Manual

MODELS QP142SS ,, QP142WW ,, QP142BL
Page 5
7" ROUND
KNOCKOUT
PLATE (also
remove 3W' x 10"
vertical plate)
3W' X 10"
VERTICAL
KNOCKOUT
3W' X 10" PLATE
KNOCKOUT
PLATE
[_ DUCTED INSTALLATION ONLY:
Remove 3W' x 10 vertical, 3W' x 10" horizontal, or 7-inch
round knockout plate(s) as appropriate for your ducting
method.
31A '' X 10" ",,_
DAMPER /
................... DUCT
,×)/%,_ o CONNECTOR _'
TOP/BACK _ ........
H DAMPER
/ _ \ _ it ----'-" FLAP
7" ROUND
DUCT
PLATE
DUCTED INSTALLATION ONLY:
Attach 31A '' × 10" Damper/Duct Connector (if using 3W'
x 10" duct) or 7" Round Duct Plate (if using 7-inch round
duct) over the knockout opening.
Notes:
To accomodate off-center ductwork, the 3W' x 10"
damper/duct connector can be installed up to Y2"on either
side of the hood center and the 7" round duct plate can
be installed up to Y2"on either side of the hood center.
Install the 3W' x 10" Damper/Duct Connector with the
Damper Flap Pivot nearest the Top/Back Edge of
Hood.
INSTALL THE HOOD
_lb ARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
\
ELECTRICAL
POWER
CABLE
KNOCKOUT
J
t
I_ Remove Electrical Wiring Box Cover from inside
of hood and appropriate Electrical Power Cable
Knockout from top or back of hood.
HOUSE
POWER CABLE
[_ Run House Power Cable between service and hood
panel
location. Attach power cable to hood using appropriate clamp.
El Hang hood from (4) mounting screws driven into
part-way
cabinet locations (shown in illustrations under "PREPARE
HOOD LOCATION"). Mounting screws are included in parts
bag. Slide hood back towards wall until mounting screw
heads are engaged in narrow end of keyhole slots in top of
hood. Tighten screws securely. Add 5th mounting screw in
center hole in hood and tighten securely.
[_ DUCTED INSTALLATION ONLY:
Connect ductwork to hood and use duct tape to make joints
secure and air-tight. Make sure the damper/duct connector
enters the ductwork and that the damper opens and closes
freely.