Install The Hood - Broan Elite 1530 Instructions Manual

INSTALL THE HOOD

1. Mark and cut-out cabinet bottom.
Prepare the cabinet bottom as shown above. Be sure to
locate the cut-out and four holes from the front of the cabinet
to assure a flush mount.
2. Attach damper/duct connector.
Use two (2) screws (provided) to attach connector to hous-
ing. Damper flap should open in direction indicated by arrow.
3. Remove electrical knockout.
Choose either the top or side of housing for electrical cable
entrance. Remove the appropriate knockout.
4. Set housing into opening.
Carefully lower housing into cabinet opening with slide
control to the front.
5. Remove access cover.
6. Open filter panel.
Pull drawer slides out. Rotate panel clips and swing panel
open.