Table of Contents
Advertisement
KEEP WATER AND SOLUTIONS OUT OF CONTROLS. NEVER SPRAY OR
WARNING
HOSE CONTROL CONSOLE, ELECTRICAL CONNECTIONS, ETC.
MOST CLEANERS ARE HARMFUL TO THE SKIN, EYES, MUCOUS
CAUTION
MEMBRANES AND CLOTHING. PRECAUTIONS SHOULD BE TAKEN TO
WEAR RUBBER GLOVES, GOGGLES OR FACE SHIELD AND
PROTECTIVE CLOTHING. CAREFULLY READ THE WARNING AND
FOLLOW THE DIRECTIONS ON THE LABEL OF THE CLEANER TO BE
USED.
CLEANING
The unit should be thoroughly cleaned once a day to insure against accumulation of
foreign material.
•
Always start with the unit cold & disconnect from its electrical source.
•
The stainless exterior can easily be cleaned using stainless steel
cleaner
•
Always follow the cleaner manufacturer's instructions when using any
cleaner.
•
Care should be taken to prevent caustic cleaning compounds from
coming in contact with the blower wheel.
•
The oven racks, rack slides, and interior may be cleaned using oven
cleaner.
•
Discoloration or heat tint may be removed using a Carbon Release
oven cleaner.
•
The oven interior should be cleaned using a mild soap and a non-metal
scouring pad. DO NOT use caustic cleaners.
Always apply these cleaners when the oven is cold and rub in
the direction of the metal's grain.
MAIN BURNER ACCESS
The main burner is removed through the top of the machine.
Remove the stainless steel top-front first by removing six sheet metal screws from
the ends.
Remove the entire top assembly by removing several sheet metal screws along the
edge of the top.
Remove the gas line from the burner at the compression fitting on the orifice.
Remove the two nuts at the opposite end of the burner from the orifice.
Lift the main burner from the machine.
MAIN BURNER ORIFICE ACCESS
The main burner orifice can be access without taking the burner from the machine.
Remove the stainless steel top-front first by removing six sheet metal screws from
the ends.
Remove the entire top assembly by removing several sheet metal screws along the
edge of the top.
Remove the gas line from the burner at the compression fitting at the orifice.
Unscrew the orifice fitting from the burner.
MAINTENANCE & CLEANING
14
Advertisement
Table of Contents
