Table of Contents
Advertisement
ALWAYS KEEP THE AREA NEAR THE APPLIANCE FREE
CAUTION
FROM COMBUSTIBLE MATERIALS.
KEEP FLOOR IN FRONT OF EQUIPMENT CLEAN AND DRY. IF
CAUTION
SPILLS OCCUR, CLEAN IMMEDIATELY, TO AVOID THE
DANGER OF SLIPS OR FALLS.
GENERAL
The Lang gas melter can be used to poach, sauté and brown. In addition to
melting cheese on sandwiches, French onion soup, hot apple pie and
casseroles, it may be used for finishing Italian, Mexican and au gratin dishes
utilizing less energy than conventional broilers.
The product is heated with 1650°F of infrared heat, which penetrates the
product preventing burning and scorching. The rack is counterbalanced so that
maximum heat is supplied only when the product is placed in the rack.
Although the heating elements are not directly controlled to regulate heat, the
exposure of the product to heat is adjustable. Heat adjustment may be obtained
by raising and lowering the rack position. The shelf positions provide a choice
of cooking positions for a variety of applications. The top position is very hot,
and can be used for quick browning and toasting, with the heat decreasing at
each lower position.
In order to change positions, simply slide the rack in and out of the slots
provided. Make sure that the end of the rack engages the sliding mechanism
located on the right front corner.
CONTROLS
There are very few controls that operate the gas cheese melter. Below is a list
of the various components with a description of their purpose.
Power Switch
Constant /
Auto Switch
Manual Gas Valve
Tilting Product Rack
Turns the unit On and Off.
When set to Constant, the burner(s) will light and
stay on. When set to AUTO, the burner(s) will light
whenever a product is placed onto the Tilting
Product Rack.
This valve turns off the flow of gas to the burner(s).
Once the machine is installed, this valve need not be
turned off as the POWER SWITCH should be
utilized to shut the machine down. The manual gas
valve cannot be used to regulate the heat output
from the burner(s), it must be full ON or full OFF.
The Tilting Product Rack is used to adjust the
amount of heat a product is exposed to and to start
the burner(s) when the machine is placed into the
Auto mode. Raising the tilting product rack
increases the heat on the product while lower the
rack decreases the heat.
12
OPERATION
Advertisement
Table of Contents
