Working With Bluetooth - Leica DISTO D3a BT User Instructions

constant to the required value using the
button. Press the button to save the constant.
Historical storage
Press this button twice and the previous 20
results (measurements or calculated results) are
shown in reverse order.
The and buttons can be used for navigation.
Press this button to use a result from the
summary line for further calculations.
Pressing the and
time erases all the values in historical storage.
Timer (self-triggering)
Press this button to set a 5-second time delay.
or
Press and hold down this button until the
desired time delay is reached (max. 60 seconds).
Once the key is released the remaining seconds until
measurement (e.g. 59, 58, 57...) are displayed in a
countdown. The last 5 seconds are counted down
with a beep. After the last beep the measurement is
taken and the value is displayed.
The timer can be used for all measurements.
Leica DISTO™ D3a BT 776750 gb
or
buttons at the same
19
Working with BLUETOOTH®
Switching on BLUETOOTH® /
sending measurements
A quick press on the
TOOTH®. The data connection must then be estab-
lished out from a Pocket PC / PC by the application
software. A BLUETOOTH® - icon will appear in the
display until this has been successfully completed.
BLUETOOTH® automatically switches off if the
connection to the Pocket PC / PC is not established
within 240 sec from when the BLUETOOTH® was
switched on.
Whilst the first connection between the
Pocket PC/PC and the DISTO™ is being established, a
prompt for the Pin-code of the DISTO™ may be
displayed. In this case, enter the code 0000 into your
Pocket PC/PC.
Switching off BLUETOOTH®
BLUETOOTH® switches off as soon as the DISTO™ is
switched off.
Working with BLUETOOTH®
- key starts DISTO™ BLUE-
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ