Rotating Gobo Removal And Installation - Philips VL4000 User Manual

❋
VARI LITE - VL4000 S

Rotating Gobo Removal and Installation

CAUTION: VL4000 spot luminaires accept glass gobos only. Use of metal gobos in these luminaires
may damage gobo assembly and will void the luminaire warranty.
To remove and replace rotating gobos:
Step 1. Before removing power from luminaire, move Edge towards front of luminaire with control
console or via luminaire menu system.
WARNING: Remove power from luminaire and allow luminaire to cool completely before
performing this procedure.
Step 2. Remove power from luminaire and allow luminaire to cool completely.
Step 3. Depending on which rotating gobo wheel you need to access, do the following:
a. For Rotating Gobo Wheel 1 (closest to the rear of luminaire), remove head cover
b. For Rotating Gobo Wheel 2 (closest to the front of luminaire), remove head cover
Captive Phillips
Screws (x4)
Head Cover Assembly
to access Rotating
Gobo Wheel 1*
CAUTION: Wear protective gloves or other protective covering while handling gobos to avoid
leaving fingerprints. If dirty, clean with isopropyl alcohol and a soft, lint-free cloth.
80
L U '
POT UMINAIRE SER S
assembly as indicated in
away from luminaire head. Note, head cover is attached by a safety tether.
assembly as indicated in
away from luminaire head. Note, head cover is attached by a safety tether.
Figure A-7: Replacing Rotating Gobos
24 J un e 20 14
M
ANUAL
Figure A-4 by loosening our captive screws and lifting cover
Figure A-4 by loosening our captive screws and lifting cover
* Each head cover is secured with a tether.
Head Cover Assembly
to access Rotating Gobo Wheel 2*
CYM / Fixed Color Assembly
(closest to lamp)
Shutter / Rotating Gobo Assembly
(closest to front lens)
Luminaire Head
Assembly
02 .9 704.00 01 0