Fixed Color Wheel Filter Removal And Installation - Philips VL4000 User Manual

❋
VARI LITE - VL4000 S

Fixed Color Wheel Filter Removal and Installation

To remove and replace fixed color filters:
Step 1. Before removing power from luminaire, move Edge towards front of luminaire with control
console or via luminaire menu system.
WARNING: Remove power from luminaire and allow luminaire to cool completely before
performing this procedure.
Step 2. Remove power from luminaire and allow luminaire to cool completely.
Step 3. Depending on which color filter wheel you need to access, do the following:
a. For Fixed Color Wheel 1 (closest to the rear of luminaire), remove head cover assembly
b. For Fixed Color Wheel 2 (closest to the front of luminaire), remove head cover
Captive Phillips
Screws (x4)
Head Cover Assembly
to access Color Wheel 1*
CAUTION: Wear protective gloves or other protective covering while handling filters to avoid
leaving fingerprints. Filters are extremely fragile and can break if not handled carefully. If dirty, clean
with isopropyl alcohol and a soft, lint-free cloth.
Note: For standard fixed color filters, refer to
Wheel 2" on page 29
78
L U '
POT UMINAIRE SER S
as indicated in Figure A-4
luminaire head. Note, head cover is attached by a safety tether.
assembly as indicated in
away from luminaire head. Note, head cover is attached by a safety tether.
Figure A-4: Replacing Fixed Color Filters
24 J un e 20 14
M
ANUAL
by loosening four captive screws and lifting cover away from
Figure A-4 by loosening our captive screws and lifting cover
"Fixed Color Wheel 1" on page 28
* Each head cover is secured with a tether.
Head Cover Assembly
to access Color Wheel 2*
CYM / Fixed Color Assembly
(closest to lamp)
Shutter / Rotating Gobo Assembly
(closest to front lens)
Luminaire Head
Assembly
or "Fixed Color
02 .9 704.00 01 0