Philips VL4000 User Manual page 60

❋
VARI LITE - VL4000 S
DMX
Parameters
Channel
51 Strobe Control
52 Control
Notes:
Default Values: *Denotes recommended console default settings.
42
L U '
POT UMINAIRE SER S
Table 4: VL4000 Spot 16-Bit Channel Mapping
Range Range
(DMX) (%)
0 - 255 0 - 100%
0 - 255 0 - 100%
24 J un e 20 14
M
ANUAL
Default
Description / Operation
Value*
Control Channel for strobing functions.
0 - 5 = Open
6 - 10 = Closed
0
11 - 15 = Normal Strobe
16 - 20 = Random Strobe
21 - 25 = Random Sync
26 - 255 = Reserved Values
To execute a command, the control channel must be set to idle (DMX 0)
then changed to a particular value and held for 3 seconds then restored
to DMX 0. Upon completion of this routine, the desired command will be
executed by the luminaire.
Used to strike/douse the lamp, set lamp levels, and other various func-
tions, as well as resetting the luminaire via the console. DMX values are:
0 - 5 = Idle (Default)
6 - 10 = Full Luminaire ReCal (1)
(1) This command is also used to Wake fixture up from shutdown
11 - 15 = Lamp ON
16 - 20 = Lamp OFF
21 - 25 = Fixture Shutdown
26 - 30 = Display - Menu ON
31 - 35 = Display - Menu OFF
36 - 40 = ReCal Position
41 - 45 = ReCal Color
0 46 - 50 = ReCal Gobo
51 - 55 = ReCal Beam
56 - 60 = ReCal Optics
61 - 65 = ReCal Dimmer/Strobe
66 - 70 = Reset Fixture to Defaults
71 - 75 = Full Luminaire Reboot (2)
(2) This command will douse lamp and reset all processors in fixture,
then ReCal all parameters.
76 - 80 = Fixture Status On/Off (3)
(3) This command will enable the display to
show fixture status for 5 min. After this time, displays will return
to default configuration. Repeating this command in less than 5
minutes will behave as a toggle.
81 - 85 = Standard Mode - Fixture operates at maximum output (Default)
86 - 90 = Studio Mode - Reduced output with lower fan settings
91 - 255 = Reserved Values
02 .9 704.00 01 0