Installation And Set Up Power Requirements - Philips SELECON PLCYC1 MKII Quick Start Manual

Led luminaire

Hide thumbs Also See for SELECON PLCYC1 MKII:

Table of Contents

QuickStart Guide

INSTALLATION AND SET UP

1. Power Requirements

WARNING! The PLCYC1 MKII LED Luminaire should be connected to a constant circuit or a relay device. It

should never be connected to a dimmer or circuit controlled by a dimmer.

The PLCYC1 MKII LED Luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The luminaire

contains an auto-ranging power supply. Depending on supply voltage, each luminaire can draw up to 140 Watts. The

maximum through current should not exceed 20 Amps*.

WARNING! *Maximum Allowable Input Current of 20 Amps (maximum power supply limit of 140 Watts). Do not

overload circuits! Must be supplied by a branch circuit protected by a maximum 20 Amp circuit protector. Doit

être alimenté par un circuit de dérivation protégé par un maximum de 20 ampères circuit protecteur. Do not

overload circuits!

IMPORTANT AC POWER CONNECTION NOTES:

a. Must be supplied by a branch circuit protected by a maximum 20 Amp

circuit protector. Doit être alimenté par un circuit de dérivation protégé

par un maximum de 20 ampères circuit protecteur.

b. When using the daisy-chain connection method, ONLY connect PLCYC1

MKII LED Luminaires to AC Output Connection of PLCYC1 MKII LED

Luminaires. DO NOT CONNECT OTHER TYPES OF LUMINAIRES

OR DEVICES!

c. Use only approved cable types.

d. Do not overload circuits!

e. Do not connect PLCYC1 MKII LED Luminaires to dimmed circuits.

f. The MAXIMUM allowable number of PLCYC1 MKII LED Luminaires

which can be 'daisy-chained' on one power feed should not exceed

ratings. DO NOT EXCEED!

INSTALLATION AND SET UP

PLCYC1 MKII LED Luminaire

Table of Contents