Key To Symbols; Symbols On The Machine And/Or In The Manual - Husqvarna 445 Operator's Manual

KEY TO SYMBOLS
Symbols on the machine and/or in
the manual"
WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
Approved protective helmet
Approved hearing protection
Protective goggles or a visor
zL
83
{#
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it with _%._)),_
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose ortipof the guide bartouchesan
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
®
Chain brake, activated (right)
Chain brake, not activated (left)
Decompression valve: Press the
valve to reduce the pressure in the
cylinder and make starting easier.You
should always use the decompression
valve when starting the machine.
<576
4}
Ignition; choke: Set the choke control
in the choke position.This should
automatically set the stop switch to the
start position.
Air purge
Adjustment of the oil pump
Other symbols/decals on the machine refer to special
certification requirements for certain markets,
Switch off the engine before carrying
out any checks or maintenance. NB!
The start/stop switch automatically
returns to run position. In order to
prevent unintentional starting, the
spark plug cap must be removed
from the spark plug when
assembling, checking and/or
performing maintenance.
Always wear approved protective gloves. [_
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be Lr";',_-'s'_
worn.
Refuelling.
Filling with oil and adjusting oil flow.
r======....._l
The chain brake should be activated when I ,_'_ I
starting.
For Canada only:
Recommended cutting
equipment in this example:
- Bar length 15 inches
- Max. nose radius 10 Teeth
- Chain type Husqvarna H30
Husqvama H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with IO _l
brake for the bar and chain combination
on the label.
Measured maximum kickback value I_ # |
without triggering the brake, for the bar
and chain combination on the label.
1154939-49 Rev.1 2012-05-05 English - 7