Cay To Symbols; Key To Symbols - Husqvarna CS 2186 Operator's Manual

Key to symbols

WARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used to
operate the chain saw. Please see page 30 in
your "Chain saw operator ' s safety manual".
Never operate a chain saw holding it with one
hand only. Please see page 30 in your "Chain
saw operator ' s safety manual".
Contact of the guide bar tip with any object
should be avoided. Please see pages 12-21
in your "Chain saw operator ' s safety
manual".
Tip contact may cause the guide bar to move
suddenly upward and backward, which may
cause serious injury. Please see pages 12-21
in your "Chain saw operator ' s safety manual".
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
Other approved bar and chain combinations
in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
Switch off the engine by moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
2 –
Canadian

CAY TO SYMBOLS

Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
Other symbols/decals on the machine
refer to special certification requirements
for certain markets.