Malfunctions Of Electric Controlling System - Zap Zaptruck-XL 2009 Owner's And Operator's Manual

-XL
TM
Solutions for Malfunctions

6. Malfunctions of Electric Controlling System

TROUBLE CODE DESCRIPTION
Over voltage protection
E-01
Driving voltage- low of IPM or IGBT failure
E-02
Motor over-current
E-03
Low voltage in the control/drive circuit
E-04
Temperature of radiator is more than 75
E-05
Battery low voltage
E-06
E-07 Over speed
Over-load of thermal sensitive relay
E-08
Running logic protection
E-09
Service brake warning
E-10
C ontactor drop voltage beyond setting value
E-11
Contactor failure
E-12
Code plate circuitry failure
E-13
Beforehand charging loop failure
E-14
Current sensor failure
E-15
REMEDY
Turn the ignition switch to the "OFF" position, restart the vehicle after the system initializes
If the problem repeats, check the controller and repair
Turn the ignition switch to the "OFF" position, restart the vehicle after the system initializes
If the problem repeats, check the controller and repair
Turn the ignition switch to the "OFF" position, restart the vehicle after the system initializes
If the problem repeats, check the controller and repair
Turn the ignition switch to the "OFF" position, restart the vehicle after the system initializes
If the problem repeats, check the controller and repair
o
Lessen the load of the vehicle; clean dust and dirt from the controller radiator
Check power battery voltage; if the voltage of the power battery is lower than 60V, check the controller and repair
Turn the ignition switch to the "OFF" position, restart the vehicle after the system initializes
Lessen the load of the vehicle
Release the parking brake and then start the vehicle; check the parking brake switch
Release the brake, and then press the accelerate pedal and start the vehicle
Check the service brake switch
Check the lap joint of the contactor; if the lap joint is burned out, replace the contactor
Check the circuitry and fuse of the relay loop; replace the contactor
Check the circuitry; replace code plate sensor
Check the circuitry; replace the beforehand charging resistance
Check the circuitry; replace the current sensor
47
Owner and Operator's Manual