Do you have a question about the QNSD250T and is the answer not in the manual?
Questions and answers
JoAnn Copeland
January 20, 2025
what is the actual location of the burner and injection holder
1 comments:
Mr. Anderson
February 4, 2025
The burner and injection holder on the Procom QNSD250T is located near the burner tube and primary air inlet holes, as shown in Figure 23 of the manual.
This answer is automatically generated
Joyce Heard
January 26, 2025
There was no hardware to fasten legs on. What size and type of screws are needed?
1 comments:
Mr. Anderson
February 10, 2025
The Procom QNSD250T requires GB/T845-4.8*16 self-tapping screws, with six pieces needed for fastening.
Need help?
Do you have a question about the QNSD250T and is the answer not in the manual?
Questions and answers
what is the actual location of the burner and injection holder
The burner and injection holder on the Procom QNSD250T is located near the burner tube and primary air inlet holes, as shown in Figure 23 of the manual.
This answer is automatically generated
There was no hardware to fasten legs on. What size and type of screws are needed?
The Procom QNSD250T requires GB/T845-4.8*16 self-tapping screws, with six pieces needed for fastening.
This answer is automatically generated