Bfd Mad Detection-Enabled Irf Configuration Example - HP A5820X Series Configuration Manual

Hide thumbs Also See for A5820X Series:

Configuration manual (200 pages)

Installation manual (146 pages)

Table Of Contents

Table of Contents

Configure LACP MAD detection

# Create a dynamic aggregation interface and enable LACP MAD detection.

<DeviceA> system-view

[DeviceA] interface bridge-aggregation 2

[DeviceA-Bridge-Aggregation2] link-aggregation mode dynamic

[DeviceA-Bridge-Aggregation2] mad enable

[DeviceA-Bridge-Aggregation2] quit

# Add ports GigabitEthernet 1/0/1 and GigabitEthernet 2/0/1 to the aggregation interface and they

are dedicated to the LACP MAD detection for Device A and Device B.

[DeviceA] interface gigabitethernet 1/0/1

[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 2

[DeviceA-GigabitEthernet1/0/1] quit

[DeviceA] interface gigabitethernet 2/0/1

[DeviceA-GigabitEthernet2/0/1] port link-aggregation group 2

Configure Device C as the intermediate device

Acting as the intermediate device, Device C needs to support LACP to forward and process LACP

protocol packets, and help Device A and Device B implement MAD detection. An LACP-supported switch

is used here to save the cost.

# Create a dynamic aggregation interface.

<DeviceC> system-view

[DeviceC] interface bridge-aggregation 2

[DeviceC-Bridge-Aggregation2] link-aggregation mode dynamic

[DeviceC-Bridge-Aggregation2] quit

# Add ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to the aggregation interface and they

are used for the LACP MAD detection.

[DeviceC] interface gigabitethernet 1/0/1

[DeviceC-GigabitEthernet1/0/1] port link-aggregation group 2

[DeviceC-GigabitEthernet1/0/1] quit

[DeviceC] interface gigabitethernet 1/0/2

[DeviceC-GigabitEthernet1/0/2] port link-aggregation group 2