Configuration Procedure - HP A5820X Series Configuration Manual

addition, for the purpose of LACP MAD, an intermediate device that supports extended LACPDUs
must be used.

Configuration procedure

This example assumes that the system names of Device A, Device B and Device C are DeviceA, DeviceB,
and DeviceC, respectively, before the IRF virtual device is formed.
Set member IDs
1.
# Keep the default member ID of Device A unchanged.
# Set the member ID of Device B to 2.
<DeviceB> system-view
[DeviceB] irf member 1 renumber 2
Warning: Renumbering the switch number may result in configuration change or loss.
Continue? [Y/N]:y
[DeviceB]
Power off the two devices and connect IRF links and LACP MAD detection links according to
2.
13. Then power on the two devices.
# Create IRF port 2 on Device A, and bind it to the physical IRF port Ten-GigabitEthernet 1/0/25. Then
save the configuration.
<DeviceA> system-view
[DeviceA] interface ten-gigabitethernet 1/0/25
[DeviceA-Ten-GigabitEthernet1/0/25] shutdown
[DeviceA] irf-port 1/2
[DeviceA-irf-port1/2] port group interface ten-gigabitethernet 1/0/25
[DeviceA-irf-port1/2] quit
[DeviceA] interface ten-gigabitethernet 1/0/25
[DeviceA-Ten-GigabitEthernet1/0/25] undo shutdown
[DeviceA-Ten-GigabitEthernet1/0/25] save
# Create IRF port 1 on Device B, and bind it to the physical IRF port Ten-GigabitEthernet 2/0/26. Then
save the configuration.
<DeviceB> system-view
[DeviceB] interface ten-gigabitethernet 2/0/26
[DeviceB-Ten-GigabitEthernet2/0/26] shutdown
[DeviceB] irf-port 2/1
[DeviceB-irf-port2/1] port group interface ten-gigabitethernet 2/0/26
[DeviceB-irf-port2/1] quit
[DeviceB] interface ten-gigabitethernet 2/0/26
[DeviceB-Ten-GigabitEthernet2/0/26] undo shutdown
[DeviceB-Ten-GigabitEthernet2/0/26] save
# Activate IRF port configuration on Device A.
[DeviceA-Ten-GigabitEthernet1/0/25] quit
[DeviceA] irf-port-configuration active
# Activate IRF port configuration on Device B.
[DeviceB-Ten-GigabitEthernet2/0/26] quit
[DeviceB] irf-port-configuration active
Master election is held between the two devices. Master election rules are followed. Device B
3.
reboots automatically and joins the Device A as a subordinate switch, and the IRF virtual device is
formed. The system name on both devices is DevcieA.
31
Figure