Accessing An Irf Virtual Device; Accessing The Master - HP A5820X Series Configuration Manual

Figure 12 Recover the IRF virtual device when the IRF link failure occurs and the IRF virtual device in
active state fails
To manually recover an IRF virtual device in recovery state:
To do...
1. Enter system view
2. Recover an IRF virtual device
in recovery state

Accessing an IRF virtual device

Accessing the master

Access an IRF virtual device in one of the following ways:
Local login: Log in through the console port of a member switch.
•
Remote login: Configure an IP address for a Layer 3 Ethernet interface of a member switch and
•
make sure that the route is reachable, and then access the IRF virtual device remotely through
Telnet, Web, or SNMP.
When you log in to the IRF virtual device, actually you log in to the master. The master is the
configuration and control center of an IRF virtual device. When you configure the IRF virtual device on
the master, the IRF virtual device synchronizes the configurations to the subordinate switches.
Use the command...
system-view
mad restore
28
Remarks
—
Required