Table of Contents
Advertisement
For more information about configuring basic IRF settings, see HP FlexFabric 5930 Switch Series IRF
Configuration Guide.
Connecting the physical IRF ports
CAUTION:
Wear an ESD-preventive wrist strap when you connect QSFP+ cables or QSFP+ transceiver modules and
fibers. For more information, see
Use QSFP+ cables or QSFP+ transceiver modules and fibers to connect the IRF member switches as
planned.
Accessing the IRF fabric to verify the configuration
To verify the basic functionality of the IRF fabric after you finish configuring basic IRF settings and
connecting IRF ports:
1.
Log in to the IRF fabric through the console port of any member switch.
2.
Create a Layer 3 interface, assign it an IP address, and make sure the IRF fabric and the remote
network management station can reach each other.
3.
Use Telnet, Web, or SNMP to access the IRF fabric from the network management station. (See HP
FlexFabric 5930 Switch Series Fundamentals Configuration Guide.)
4.
Verify that you can manage all member switches as if they were one node.
5.
Display the running status of the IRF fabric by using the commands in
Table 5 Displaying and maintaining IRF configuration and running status
Task
Display information about the IRF fabric.
Display all members' IRF configurations that take
effect at a reboot.
Display IRF fabric topology information.
NOTE:
To avoid IP address collision and network problems, configure at least one multi-active detection (MAD)
mechanism to detect the presence of multiple identical IRF fabrics and handle collisions. For more
information about MAD detection, see
QSFP+ Transceiver Modules/Cables Installation Guide
Command
display irf
display irf configuration
display irf topology
HP FlexFabric 5930 Switch Series IRF Configuration Guide
33
.
Table
5.
.
Advertisement
Table of Contents
