Install Vent System; Connect Inlet Hoses - Kenmore 11078103310 Installation Instructions Manual

INSTALL VENT SYSTEM
1. Install exhaust hood
12" rain.
(305 ram)
install exhaust hood and use caulking compound to seal
exterior wall opening around exhaust hood.
2. Connect vent to exhaust hood
Vent must fit over the exhaust hood. Secure vent to exhaust
hood with 4" (102 mm) clamp. Run vent to dryer location using
straightest path possible. Avoid 90 ° turns. Use clamps to seal all
ioints. Do not use duct tape, screws, or other fastening devices
that extend into interior of vent to secure vent, because they
can catch lint.
CONNECT iNLET HOSES
For non=steam models, skip to "Connect Vent."
The dryer must be connected to the cold water faucet using the
new inlet hoses. Do not use old hoses.
1. Turn cold water off, remove and
replace rubber washer
®
®
®
Turn cold water faucet off and remove washer inlet hose.
Check and see if rubber washer is in the "Y" connector. Remove
old rubber washer from inlet hose and replace with new rubber
washer provided.
If space permits, attach the female end of the "Y" connector
to the cold water faucet. See figure A.
If "Y" connector cannot be attached directly to the cold water
faucet, the short hose must be used. See figure B. Attach short
hose to cold water faucet. Screw on coupling by hand until
it is seated on faucet. Then attach "Y" connector to male end
of the short hose. Screw on coupling by hand until it is seated
on connector.
Tighten couplings
16
Using pliers, tighten the couplings with additional two=thirds turn.
NOTE: Do not overfighten. Damage to the coupling can result.