Kenmore 11078103310 Installation Instructions Manual page 9

if your outlet looks like this:
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "4-Wire Power Supply Cord
Connection" on this page.
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "3-Wire Power Supply Cord
Connection" on page 10.
4-wlre Power Suppty Cord Connection
iMPORTANT: A 4-wire connection is required for mobile homes
and where local codes do not permit the use of 3-wire connections.
4-wire receptacle (NEMA
type 14-30R)
Spade terminals with
upturned ends
4-prong plug
Ring terminals
neutral wire
Connect neutral ground wire (E) and neutral wire (white) (C)
of power supply cord under center terminal block screw (B),
Tighten screw.
Connect ground wire
Connect ground wire (F) (green or bare) of power supply cord
to external ground conductor screw (A). Tighten screw.
1. Prepare to connect neutral
ground wire and neutral wire
Remove center terminal block screw (B). Remove neutral ground
wire (E) from external ground conductor screw (A).
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally_ reinsert tab of terminal block cover into
slot of dryer rear panel. Secure cover with hold-down screw.
Now, go to "Venting Requirements."