Kenmore 11078103310 Installation Instructions Manual page 17

tighten couplings
One end of the long hose has a wire mesh strainer inside the
coupling. Attach this end to the _Y" connector. Attach washer
cold inlet hose to other side of _Y" connector. Screw on coupling
by hand until it is seated on connector. Using pliers, tighten the
couplings an additional two-thirds turn.
NOTE: Do not overfighten. Damage to the coupling can result.
5. Attach long hose to dryer fill valve
tighten coupling
Attach other end of long hose
to fill valve at bottom of dryer
back panel. Screw on coupling
by hand until it is seated on fill
valve connector. Using pliers, tighten
the coupling an additional two-
thirds turn.
NOTE: Do not overtJghten. Damage
to the coupling can result.
6. Turn on cold water faucet
Check that the water faucets are turned on.
f 7. Check for leaks
Check for leaks around _"Y" connector, faucets, and hoses.
17