Omron POWLI BU100XR2 Instruction Manual page 24

2. Installation and connection
(4) Remove the AC Input Plug of the UPS from a wall outlet (commercial power) to bring it into backup status.
Under this condition, check the indicating lamp and hear beep from the UPS.
Which figure does the display of your USP show below?
バイパス
運転
AC入力
バッテリ
残量
異常
Beep
The operation is normal.
Yes
→
Proceed to (5).
The operation is abnormal.
No
→
• If the display is either of them showed in "C. Display and beeper when a failure occurs in
devices" of "3-4 Beep sound, and how to look at the display" on page 28, take necessary
measures according to the troubleshooting and then go back to (4).
• In a case where there is no backup and both the UPS and devices linked to the UPS would
stop, a weak charge state of the battery is suspected.
Put the AC Input Plug of the UPS in a wall outlet (commercial power), charge the battery for
at least 8 hours, and then go back to (4).
♦ Despite efforts to the above two checks, and the trouble still remains, contact our custom support center
at 0120-77-4717.
(5) Put the AC Input Plug in a wall outlet (commercial power)
again.
The Battery mode Lamp goes out, the AC Input Lamp
goes on, and a beeper stops.
(The status is shown in the right figure.)
The operating checks are now complete.
電源出力
テスト／ブザー停止
運転
停止
バックアップ
運転
接続容量 バッテリ 入力15A
オーバー 交換 オーバー
A beep every 4 seconds
バイパス
運転
AC入力
バッテリ
残量
異常
Beep
AC入力
バッテリ
残量
22
電源出力
テスト／ブザー停止
運転
停止
バックアップ
運転
接続容量 バッテリ 入力15A
オーバー 交換 オーバー
A beep every 1 second
Light is on or
Light Light
off depending
is on is off
on the status.
電源出力
テスト／ブザー停止
バイパス
運転
バックアップ
運転
接続容量 バッテリ 入力15A
異常 オーバー
オーバー 交換
運転
停止