Glowing Ember Placement; Lava Rock - Napoleon HDX40NT-1 Installation And Operating Instructions Manual

Align the holes in the bottom of the right log (W135-0447) with the
E.
pins in the rear and front right log.
Align the holes in the bottom of the middle log (W135-0445) with
F.
the pins in the front left and right logs.
Align the hole in the bottom of the left log (W135-0446) with the pin
G.
in the rear log. Resting the right side of the log against the burner.
Align the hole in the bottom of the front log (W135-0449) with the
H.
pin in the charcoal strip. Rest the right side of the log against the
far right grate post.
6.3

GLOWING EMBER PLACEMENT

Tear the embers into pieces and place on top of the front burner area behind
the charcoal strip. Care should be taken to shred the embers into thin, small
irregular pieces as only the exposed edges of the fi bre hairs will glow. The em-
ber material will only glow when exposed to direct fl ame; however, care
should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and
delayed ignition. PHAZER
certifi ed "glowing embers" and PHAZER
dealer.
6.4

LAVA ROCK

Lava rock should be spread out evenly around the burner on the fi rebox base.
NOTE: Lava rock is not to be placed on the burner.
logs glow when exposed to direct fl ame. Use only
TM
logs available from your Authorized
TM
31
GLOWING EMBERS GLOWING EMBERS
W415-1089 / 08.08.12